Author Topic: PC in a Drawer  (Read 151 times)

Offline jeremypv

  • Member
  • **
  • Posts: 1119
    • jeremypv.net
PC in a Drawer
« on: January 03, 2021, 10:50:29 AM »
trying to tidy my table, so I though of a weekend project, the Drawer PC (tm)


from here:


to here:


test fit on the drawer:


then test run:


unfortunately, I ran out of some materials, so this project will be continued next weekend.  :lol:
jeremypv

Online lahar

  • Member
  • **
  • Posts: 8024
Re: PC in a Drawer
« Reply #1 on: January 03, 2021, 12:11:20 PM »
Nice. Bihira na ang gumagawa ng custom case mods ngayon. Puro RGB na lang.

Offline Mr. Bungle

  • Member
  • **
  • Posts: 1132
Re: PC in a Drawer
« Reply #2 on: January 03, 2021, 04:14:58 PM »
Nice. I'm curious to see how the airflow intake and exhaust will be done on that drawer.

Offline Sephiroth

  • Member
  • **
  • Posts: 6300
Re: PC in a Drawer
« Reply #3 on: January 03, 2021, 04:35:05 PM »
Nice. Bihira na ang gumagawa ng custom case mods ngayon. Puro RGB na lang.
Made a meme from that :lol:


Offline jeremypv

  • Member
  • **
  • Posts: 1119
    • jeremypv.net
Re: PC in a Drawer
« Reply #4 on: January 03, 2021, 04:45:20 PM »
managed to find some zipties and a flat wood drill bit, now these are the only ones needed to be mounted to on the drawer, these displayport switch which supports 2560x1440 @144Hz are a godsend, so I don't need to find a long displayport cable



a very un-assuming drawer  >:D


Nice. I'm curious to see how the airflow intake and exhaust will be done on that drawer.
I was using an Elite 361 case prior, just adding one 120mm outtake at the back of the drawer made the thermals the same as the Elite361
jeremypv